Star Micronics TSP743II Series, Руководство по оборудованию

Страница: 15 / 33

3-6-1. Compliant Paper Roll Specifications
Paper thickness 65 to 75 μm:
f
18±1mm(Core outer),
f
18±1mm(Core outer)
Thermal Paper 65 to 75 μm:
f
32±1mm(Core outer),
f
25.4±1mm(Core outer)
75 to 150 μm:
f
32±1mm(Core outer),
f
25.4±1mm(Core outer)
Thermal Label Paper
Max.150 μm
Paper width Thermal Paper
79.5 ± 0.5 mm or 82.5 ± 0.5 mm or 57.5 ± 0.5 mm
Thermal Label Paper
79.5 ± 0.5 mm or 82.5 ± 0.5 mm
External dimensions
• Roll diameter
Max.
f
100 mm
• Take up paper roll width
80
+0.5
mm / 83
+0.5 mm / 58 +0.5 mm
Printed surface
Outer edge of roll
Note 1: Do not glue or tape the paper roll and shaft core together.
2: Do not fold the tail end of the paper.
3: For details on recommended thermal paper, see the following webpage.
http://www.starmicronics.com/support/
- 1 - 1 - 1
3-6-2. Removing the Tension Bar
When using thermal paper roll, the tension bar unit may or may not be necessary, depending on the paper thickness,
paper width, or the installation layout. If the tension bar unit is unnecessary, remove it in accordance with the procedure
indicated below. The tension bar unit is unnecessary when using full-face thermal label paper roll or thermal label paper
roll (tack label paper).
Installation layout Horizontal Vertical/wall-mount
Paper width (mm) 82.5 79.5 57.5 82.5 79.5 57.5
Paper thickness
between 65 μm and 100 μm
Necessary Necessary Necessary Necessary Necessary Un-
necessary
Paper thickness
between 100 μm and 150 μm
Un-
necessary
Un-
necessary
Un-
necessary
Un-
necessary
Un-
necessary
Un-
necessary
Use a flat head screwdriver as shown to remove the clips at both
ends of the tension bar. Then, remove the tension bar unit.
- 15 -
Vertical Wall-mount
Horizontal