Star Micronics TSP743II Series, Руководство по оборудованию, Страница: 14 / 33

( 5 ) Load the paper roll into the printer in the direction indicated by the figure, and pull the leading edge of the paper
straight toward you.
(
6
) Push on both sides of the rear cover to close it.
Note 1: Be careful not to pull the paper out at an angle, because doing so may cause the paper to jam or skew.
2: Be sure not to close the printer cover by pushing only one side.
3: Be careful not to get your fingers caught when opening or closing the printer cover.
4: After the printer cover is closed, the printer performs initial operations (from paper feeding to paper
cutting). Do not open the printer cover until the initial operations are complete.
Note: Make sure not to pass the paper under the tension bar. In the following condition, remove the tension bar
unit and change the adjustment lever position in accordance with the procedures described in paragraphs
3-6-2 and 3-6-3:
*
Paper thickness between 100 μm and 150 μm, or paper width of 57.5 mm on the vertical/wall-mount layout.
Paper roll
- 14 -