Stanley tp03, Руководство пользователя

Страница: 6 / 19

6
Tool operators and maintenance personnel must always comply with the safety
precautions given in this manual and on the stickers and tags attached to the tool
and hose.
These safety precautions are given for your safety. Review them carefully before
operating the tool and before performing general maintenance or repairs.
Supervising personnel should develop additional precautions relating to the specifi c
work area and local safety regulations. If so, place the added precautions in the
space provided in this manual.
The models TP03 Hydraulic Trash Pump will provide safe and dependable service if
operated in accordance with the instructions given in this manual. Read and under-
stand this manual and any stickers and tags attached to the tool and hoses before
operation. Failure to do so could result in personal injury or equipment damage.
• Operator must start in a work area without bystanders. The operator must be familiar with all prohibited work areas
such as excessive slopes and dangerous terrain conditions.
• Establish a training program for all operators to ensure safe operations.
• Do not operate the tool unless thoroughly trained or under the supervision of an instructor.
• Always wear safety equipment such as goggles, head protection, and safety shoes at all times when operating
the
tool.
• Do not inspect or clean the tool while the hydraulic power source is connected. Accidental engagement of the
tool can cause serious injury.
• Do not operate this tool without fi rst reading the Operating Instructions.
• Do not install or remove this tool while the hydraulic power source is connected. Accidental engagement of
the tool can cause serious injury.
• Never operate the tool near energized transmission lines. know the location of buried or covered services before
starting
work.
• Do not wear loose fi tting clothing when operating the tool. Loose fi tting clothing can get entangled with the
tool and cause serious injury.
• Supply hoses must have a minimum working pressure rating of 2500 psi/175 bar.
• Be sure all hose connections are tight.
• The hydraulic circuit control valve must be in the “OFF” position when coupling or uncoupling the tool. Wipe all couplers
clean before connecting. Failure to do so may result in damage to the quick couplers and cause
overheating. Use only lint-free cloths.
• Do not operate the tool at oil temperatures above 140° F/60° C. Operation at higher oil temperatures can
cause operator discomfort and may cause damage to the tool.
• Do not operate a damaged, improperly adjusted, or incompletely assembled tool.
SAFETY PRECAUTIONS
To avoid serious injury or death
WARNING