Stanley STGS1011, Инструкция по эксплуатации

Страница: 24 / 26

24 • ENGLISH
replaced daily or whenever the wearer has difficulty
breathing.
Note: only those dust masks suitable for working with
lead paint dust and fumes should be used. Ordinary
painting masks do not offer this protection. See your
local hardware dealer for the NIOSH approved proper
mask.
Environmental safety
f
Paint should be removed in such a manner as to
minimize the amount of dust generated.
f
Areas where paint removal is occurring should be
sealed with plastic sheeting of 4 mils thickness .
f
Sanding should be done in a manner to reduce
tracking of paint dust outside the work area.
GENERAL INFORMATION
Helpful hints
f
Hold your angle grinder with one hand on the body
and the other hand firmly around the side handle as
shown in Fig. I.
f
Always position the guard so that as much of the
exposed disc as possible is pointing away from you.
f
Be prepared for a stream of sparks when the disc
touches the metal.
f
Maintain an angle between the disc and work surface
(Fig. J) of approximately 30° when grinding and 10°-
15° when sanding (Fig. K) for best tool control,
material removal, and minimal loading.
Caution! Use extra care when grinding into a corner
as a sudden, sharp movement of the grinder may be
experienced when the wheel contacts a secondary
surface.
Warning! Always wear eye protection while operating
this power tool.
LUBRICATION
STANLEY tools are properly lubricated at the factory and
are ready for use. Tools should be lubricated regularly
every year depending on usage. (Tools used on heavy
duty jobs and tools exposed to heat may require more
frequent lubrication.) This lubrication should be attempted
only by trained power tool repairperson’s such as those
at STANLEY service centers or in other qualified service
personnel.
CLEANING
Blowing dust and grit out of the motor housing using
compressed air is a necessary maintenance procedure.
Caution! Dust and grit from metal grinding often
accumulate on interior surfaces and could create an
electrical shock hazard if not cleaned out. Use only mild
soap and a damp cloth to clean the tool. Never let any
liquid get inside the tool; never immerse any part of the
tool into a liquid.
¡Important! To ensure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(other than those listed in this manual) should be performed
by authorized service centers or other qualified organizations,
always using identical replacement parts. Unit contains no
user service able parts inside.
ACCESSORIES
The performance of any power tool is dependent upon the
accessory used. STANLEY accessories are engineered
to high quality standards and are designed to enhance the
performance of power tool. By using STANLEY accessories
will ensure that you get the very best from your STANLEY tool.
STANLEY offers a large selection of accessories available at
our local dealer or authorized service center at extra cost.
REMARKS
f
STANLEY’s policy is one of continuous improvement
to our products and, as such, we reserve the right to
change product specifications without prior notice.
f
Standard equipment and accessories may vary by
country.
f
Product specifications may differ by country.
f
Complete product range may not be available in all
countries. Contact your local STANLEY dealers for
range availability.
PROTECTING THE ENVIRONMENT
Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your STANLEY
product needs replacement, or if it is of no further
use to you, do not dispose of it with household
waste. Make this product available for separate
collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.