12- ENG
G. Handle
H. Frame
I. Pump Outlet
J. Pump Inlet
K. Quick Connect Nozzles
L. Adjustable Pressure Regulator:
Use the adjustable pressure regulator
to increase and decrease the pressure. Refer to the
Adjustable Pressure
Regulator Adjustment
paragraph.
BASIC ELEMENTS OF AN ENGINE
Refer to the
Engine Owner’s Manual
for location and operation of engine controls.
Choke Control:
Opens and closes carburetor choke valve.
Starter Grip:
Pulling starter grip operates recoil starter to crank engine.
Engine Switch:
Enables and disables ignition system.
ASSEMBLY INSTRUCTIONS (FIG. 2 – 4)
1. Locate and remove all loose parts from the carton.
2. Cut four corners of the carton from top to bottom and lay the panels flat.
3. Place handle (G) onto frame (H),
G
H
2
Q
2A
K
depress the snap buttons, and slide
the handle assembly onto the frame
until snap buttons snap into place.
NOTICE:
Risk of personal injury. Avoid
placing hands between handle and frame
when assembling to prevent pinching.
4. Remove the colored quick-connect
nozzles (K) from the plastic bag and insert them into correct grommet on the nozzle
holder. Nozzles are color coded to match colored nozzles on label (Q).
5. Slide the axle pin through the wheel and flat washer (Figure 3). Slide the axle pin
through the hole in the frame (Figure 3A). Slide clip through hole in axle pin to
secure wheel in place (Figure 3B). Repeat same steps for second wheel.
NOTICE: Keep machine level during wheel installation process. Do
not tilt, tip over, or turn upside down to install wheel kit. May
cause damage!
3
3A
3B
6. Connect wand (E) to gun (D). Tighten securely.
7. Attach high pressure hose (C) to gun (D). Tighten se cure ly.
