8- ENG
QUICK SETUP GUIDE
DANGER:
To reduce the risk of injury, read the pressure washer instruction manual
and the engine instruction manual before operating pressure washer.
A
Install the
Handle
Place handle
onto frame, depress the
snap buttons, and slide
the handle assembly
onto the frame until snap
buttons snap into place.
B
Add/Check Oil
The engine is
shipped without
oil. Before starting engine,
add the oil. Check
oil level prior to each
use. Refer to
Engine
Owner’s Manual
for
complete procedure.
C
Add Gasoline
In a well ventilated
outdoor area
add fresh, high quality,
unleaded gasoline with
a pump octane rating
of 86 or higher. Do not
overfill. Wipe up spilled
fuel before starting the
engine. Refer to
Engine
Owner’s Manual
for
complete procedure.
IMPORTANT:
Ethanol Shield
TM
(sold separately) is a fuel stabilizer that helps eliminate
and prevent ethanol related problems in power equipment. Follow the instructions on the
container and add to the gasoline.
Wheel Installation
Slide the axle pin through the wheel and flat washer. Slide the axle pin through the hole
in the frame Slide clip through hole in axle pin to secure wheel in place. Repeat same
steps for second wheel.
NOTICE: Keep machine level during wheel installation process.
Do not tilt, tip over, or turn upside down to install wheel kit. May
cause damage!
