Stanley Fatmax FMHT0-77421, Руководство пользователя

Страница: 13 / 196

13
GB
2-YEAR WARRANTY
Stanley warrants its electronic measuring tools against
deficiencies in materials and/or workmanship for 2 years from
date of purchase.
Deficient products will be repaired or replaced, at
Stanley’s option, if sent together with proof of purchase to:
Stanley Black & Decker
210 Bath Road
Slough, Berkshire SL1 3YD
UK
This Warranty does not cover deficiencies caused by accidental
damage, wear and tear, use other than in accordance with the
manufacturer’s instructions or repair or alteration of this product
not authorised by Stanley.
Repair or replacement under this Warranty does not affect the
expiry date of the Warranty. To the extent permitted by law,
Stanley shall not be liable under this Warranty for indirect or
consequential loss resulting from deficiencies in this product.
This Warranty may not be varied without the authorisation of
Stanley. This Warranty does not affect the statutory rights of
consumer purchasers of this product. This Warranty shall be
governed by and construed in accordance with the laws of the
country sold where in and Stanley and the purchaser each
irrevocably agrees to submit to the exclusive jurisdiction of the
courts of that country over any claim or matter arising under or
in connection with this Warranty.
Calibration and care are not covered by warranty.
NOTE:
The customer is responsible for the correct use and care of the
instrument.
Subject to change without notice
DISPOSAL OF THIS ARTICLE
Dear Customer,
If you at some point intend to dispose of this
article, then please keep in mind that many of its
components consist of valuable materials, which can
be recycled.
Please do not discharge it in the garbage bin, but
check with your local council for recycling facilities
in your area.
Troubleshooting
Problem Possible Cause Possible Solution
Display will not
turn on
1. not
held down
long enough.
2. Battery needs to
be charged.
1. Hold for
>3 seconds.
2. Attach power
supply to
charge battery.
Buttons do not
work
Low battery or
camera frozen
1. Straighten a paper
clip.
2. Insert the end of
the paper clip into
the RESET hole
(Figure
A
42
).
Display not
charging
1. Power supply not
correctly inserted
in charger port.
2. Power supply
not connected
to power.
1. Check connection
of adapter to
charging port.
2. Check that power
supply is properly
plugged into
outlet.
3. Check outlet
for power.
Error Message
displayed: See
Manual for
Troubleshooting
or No Video
1. Power to camera/
handle is off.
2. Batteries low in
camera/handle.
3. Wand not properly
connected
to handle.
1. Check that power
switch is on.
2. Check the charge
state of the
AA batteries.
3. Check connection
of the wand to
the handle.
Image too dark or
bright
1. LEDs not set to
proper brightness
1. Adjust LED
brightness
with switch.
Follow all safety protocols when diagnosing issues with
the tool.
Li-ion