Installation Instructions for 83KM/93KM–85KM/95KM IDH Max Cylindrical Locks
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc
13
Installation Instructions for 83KM/93KM–85KM/95KM IDH Max Cylindrical Locks
Installing the lock & through-bolt trim
15
Install trim hole insert, bushing, and
hub washer
1 Insert the trim hole insert into the upper trim hole on
the outside of the door, as shown in Figure 15.
2 For LH and LHRB doors
Insert the bushing into the door status switch &
LH/LHRB reader wire hole on the outside of the door,
as shown in Figure 15.
For RH and RHRB doors
Insert the bushing into the field harness & RH/RHRB
reader wire hole on the outside of the door.
3 On each side of the door, slide a hub washer over the
chassis sleeve so it rests on the hub.
Note: You do
not
need to change the positions of the
DIP switches on the control electronics circuit board
located in the inside escutcheon.
■
By default, switches 1 through 5 are set to ON.
These switches are for possible future applications.
■
By default, switches 6 and 7 are set to ON for
automatic baud rate detection. This setting lets you
determine the baud rate for communication
between the lock’s control electronics circuit board
and the panel interface module by setting DIP
switches on the panel interface circuit board. (See
page 22.)
■
Switch 8 is set to OFF for locks with a swipe-type
magnetic stripe card reader, a proximity reader, or
a keypad reader; it is set to ON only for locks with
an insertion-type magnetic stripe card reader.
Figure 15 Installing the trim hole insert, bushing, and
hub washer
Hub washer
Inside of door
Outside of
door
Hub washer
Hub
Hub
Trim hole
insert
Bushing
Solenoid
wire
