8
•
Using spatula (07900-00006), remove the wiper (Item 4). Inspect for wear and replace as necessary.
•
Using spatula (07900-00006), remove the seal (Item 7) from the body (Item 2). Care must be taken not to damage the
sealing surfaces of the body (Item 2).
•
Remove the bearing strip (Item 5) from the body (Item 2). Inspect for wear and replace as necessary.
Assembly Instructions:
•
Clean all the parts thoroughly. Inspect and replace any parts that are worn or damaged. Lubricate the seals (items 7 & 8)
and the bore of the body (item 2), with Moly Lithium Grease (07992-00020).
•
Assembly is the reverse procedure for dismantling.
•
Ensure that the seals (Items 7 & 8) and the wiper (Item 4), are replaced in the correct orientation. Lubricate all seals and
housings, with Molylithium Grease (07992-00020).
• When
fi tting the piston (Item 1) into the body (Item 2), it is essential that the assembly bullets (07900-00693) and
(07900-00694) are used to prevent seal damage.
•
The jaw spreader housing assembly (Item 14) must be screwed onto the piston (Item 1) to a torque of 27 Nm (20lbsf ft).
All item numbers refer to the General Assembly and Part List in section 6.0.
5.7 PROTECTING THE ENVIRONMENT
•
Assure conformity with applicable disposal regulations. Dispose all waste products at an approved waste facility or site
so as not to expose personnel and the environment to hazards.
E N G L I S H O R I G I N A L
I N S T R U C T I O N
