Standart Horizont CP190i, Руководство пользователя

Страница: 15 / 123

CP190i Page 17
2. To ease installation a flush mounting template for the antenna has been included.
3. Apply the mounting template sticker to the area that was verified for GPS reception.
4. Then, drill out the 0.78” (20mm) and 0.13” (3.2mm) holes, and remove the template.
5. Insert the cable into the 0.78” (20mm) hole and route to the GPS Chart Plotter.
6. Apply a small amount or RTV to the underside of the antenna.
7. Place the antenna and then screw it into place using the screws.
NOTE
In some cases the screw may not be long enough. If this happens simply apply more RTV to the
underside of the antenna to glue it into place.
S8002348
Figure 2.3.0 - Installing the External GPS antenna
Smart GPS Cable
Pin Wire Color Description
1 Red Battery Positive
2 Green Smart GPS NMEA Input
3 Brown Smart GPS NMEA Output
4 NC
5 NC
6 Black/Yellow Battery Ground
2.4 CONNECTIONS
The CP190i has connectors that allow them to be connected to a Power supply, optional
WAAS GPS antenna, optional FF525 50/200kHz Black Box Fish Finder and NMEA
Devices* such as VHFs, AIS Receiver, Digital Instruments and Autopilots.
NOTE*
RS232 not opto-isolated electrical interface.
NOTE
The GPS Chart Plotter can send many sentences to external NMEA devices*. The NMEA Output
wires are yellow and white. If you have connected devices as shown in the table on the next page
and need to feed NMEA to other devices (Autopilot, RADAR…) you can parallel wires from the
yellow, brown or white wires to other devices.