GX5500S
Page 14
6.3.2 Optional MMB-84 Flush Mount Bracket
0DNHDUHFWDQJXODUWHPSODWHIRUWKHÀXVKPRXQWPHD[´
W (72 x 205 mm).
2. Use the supplied template to mark the location where the rectangular hole
LVWREHFXW&RQ¿UPWKHVSDFHEHKLQGWKHGDVKRUSDQHOLVGHHSHQRXJK
to accommodate the transceiver (at least 6 inches (150 mm) deep).
There should be at least 1/2 inch (1.3 cm) between the transceiver’s
heatsink and any wiring, cables or structures.
3. Cut out the rectangular hole and insert the transceiver.
4. Fasten the brackets to the side of the transceiver with the lock-washer
QXW FRPELQDWLRQ VR WKDW WKH PRXQWLQJ VFUHZ EDVH IDFHV WKH PRXQWLQJ
surface (see the illustration below).
5. Turn the adjusting screw to adjust the tension so that the transceiver is
tight against the mounting surface.
MMB-84 Mounting Bracket
Adjusting Screw
Lock-washer nut combination