FCC ID:K6630323X30
IC: 511B-30323X30
Vertex Standard Co.,Ltd.
11
voltage will indicated on the display for 2 seconds.
2.
Press the [SQL] key to activate the squelch adjusting mode. Press the [
T
] key until the SQL
level is “00” then press the [SQL] key again (or wait 3 seconds to exit from the squelch
adjusting mode). This state is known as “Squelch Off”.
3.
Press the [VOL] key to activate the volume adjusting mode. Press the [
T
]/[
S
] key until the
noise or audio from the speaker is at a comfortable level, then press the [VOL] key again (or
wait 3 seconds to exit from the volume adjusting mode).
4.
Press the [SQL] key, then press the [
S
] key until the random noise is disappeared. This state is
known as the “Squelch Threshold”.
5.
Press the [
T
] or [
S
] key to select the desired channel. Refer to the channel chart on page 39
for available channels.
6.
When a signal is received, adjust the volume (Press the [VOL] key, followed by the [
T
]/[
S
]
key) to desired listening level. The TX/BUSY indicator illuminates green indicating that the
channel is being used.
NOTE
You may change the speaker audio to have a high or lower sounding pitch to assist listening in
quiet or noisy environments. See Menu item “02 PC (AUDIO PITCH CONTROL)” (page 23) for
details.
6.4 TRANSMISSION
1.
Perform steps 1 through 7 of the “6.3 RECEPTION” discussion above.
2.
Before transmitting, monitor the channel and make sure it is clear.
THIS IS AN FCC REQUIREMENT!
3.
For communications over short distances, press the [H/L(LOCK)] key until “L” is displayed on
the LCD. This indicates Low power (approximately 1 watt).
Note
: Transmitting on 1 watt prolongs battery life. Low power (1 watt) should be selected
whenever possible.
4.
If using Low power is not effective, select Medium power (2.5 watts: “M” icon appears), High
power (5 watts: “H” icon appears), or Normal power (6 watts: No icon) by pressing the
[H/L(LOCK)] key.
5.
When receiving a signal, wait until the incoming signal stops before transmitting. The
transceiver cannot transmit and receive simultaneously.
6.
Press the PTT (Push-To-Talk) switch to transmit. During transmission, the “TX” indicator will
appear on the display and the TX/BUSY indicator will grow red.
7.
Speak slowly and clearly into the microphone. Hold the microphone about 1 inch (2.5 cm)
away from your mouth.
