GX3500S
Page 46
Manual Calling
You may enter an MMSI number
manually
to contact without the Setting up the
Individual Directory.
1. Press the [
CALL
(
MENU
)] key. The “
DSC Operation
”
menu will appear.
2. Turn the
CHANNEL
selector knob to select “
Indi-
vidual
.” (To cancel, select “
Exit
” with the
CHANNEL
selector knob or press the [
16/9
] key.)
3. Press the [
ENT
] key. The transceiver will beep, and
the “Individual directory” will appear.
4. Turn the
CHANNEL
selector knob to select “
Manual
,”
then press the [
ENT
] key.
5. Enter the MMSI number (nine digits) which you want
to contact by the keypad, then press the [
ENT
] key.
6. Turn the
CHANNEL
selector knob to select “
Manual
,”
then press the [
ENT
] key.
7. Turn the
CHANNEL
selector knob to select the oper-
ating channel which you want to
use for
communica-
tion, then press the [
ENT
] key.
8. Press the [
ENT
] key again to transmit the individual
DSC signal.
9. After INDIVIDUAL CALL is transmitted, the trans-
ceiver will wait 8 seconds for the acknowledgment. If
the reply signal is not received, the transceiver will
transmit again.
10. After the second INDIVIDUAL CALL is transmitted, if
the reply signal is not received, the display will be as
shown in the illustration on the right. To send the call
again, press the [
ENT
] key or to exit the mode, press
the [
CLR
] key.
11. When an individual call acknowledgment is received,
the established channel is automatically changed to
the channel which is selected on step 5 above and a
ringing tone sounds.
9. Press any key to listen to the channel to make sure it is not busy, then key
the microphone and call the other vessel you desire to communicate with.
Vertex Standard Co., Ltd.
FCC ID: K6630063X30 / IC ID: 511B-30063X30
