ASSEMBLY INSTRUCTIONS
12
STEP 9:
There is an
“L”
decal on the
LEFT PIVOTING ARM(9),
and an
“R”
decal on the
RIGHT PIVOTING
ARM(10).
To assemble the
RIGHT PIVOTING ARM(10),
place a
SPACER(50)
and a
LARGE WASHER
(M16)(51)
onto the right side of the
SHAFT
on the
UPRIGHT(6).
Slide the
RIGHT PIVOTING ARMS(10)
onto
the
SHAFT
and secure with a
LARGE WASHER(M8)(44), LOCK WASHER(M8)(75),
and
BUTTON HEAD
BOLT(M8x1.25x20mm)(59).
Attach the
LINKAGE(11)
to the
RIGHT PIVOTING ARM(10)
with the
PLASTIC
WASHERS(M8)(48), BUTTON HEAD BOLTS(M8x1.25x48mm)(60),
and
NYLOCK NUTS(M8x1.25)(68).
Repeat on the left side.
L
R
L
R
STEP 12:
Install two AA batteries into the
METER(32),
the batteries are not included. See page 15 for
detailed battery installation instructions. Remove the red strap from the
SENSOR WIRE(33).
Plug the
SENSOR WIRE(33)
into the
METER(32),
and push the excess wire back into the
UPRIGHT(6).
Slide the
METER(32)
onto the plate on the
UPRIGHT(6).
STEP 11:
Look down from the top of the
UPRIGHT(6)
to make sure the pivot tubes on the
PIVOTING
ARMS(9, 10)
are parallel to the
FRONT STABILIZER(2)
and the
PEDAL ARMS(4, 5)
are crossing the
ROLLERS(54)
properly. Tighten the
BUTTON HEAD BOLTS(M8x1.25x20mm)(59)
as described in
STEP 3
on the
UPRIGHT(6).
STEP 10:
Attach the
LEFT
and
RIGHT HANDLEBARS(7, 8)
to the
LEFT
and
RIGHT PIVOTING ARMS
(9, 10)
with
HEX BOLTS(M6x1x36mm)(63), ARC WASHERS(M6)(72), LOCK WASHERS(M6)(74),
and
ACORN NUTS(M6x1)(70).
The
HEX BOLTS(M6x1x36mm)(63)
fit inside the hex-shaped holes in the
HANDLEBARS(7, 8).
Shaft
Shaft
