SET UP INSTRUCTIONS
LEVELING:
MOVING:
Equipment Mat
Place the
Avari GX8
in the area where it will be used. It is recommended that the
Avari GX8
be placed
on an equipment mat. The maximum usage dimensions of
Avari GX8
are approximately 99 1/4" long x
25 5/8" wide x 64 7/8" tall. (These dimensions may vary up to one inch.) An area 4 feet wide x 9 feet long is
required for safe operation of the
Avari GX8.
Make sure that adequate space is available for access to and
passage around the
Avari GX8.
Adjust the
STANDS(59)
under the
MAIN FRAME(1)
so that the
Avari GX8
sits on the floor
without rocking. Refer to the instructions below the illustration.
Move the
Avari GX8
with the moving wheels on the
REAR STABILIZER(2).
Lift from the
Front Stabilizer of the
MAIN FRAME(1).
Two people are required to move the
Avari GX8.
12
Lift up from the Front
Stabilizer for moving.
FUNCTION INSPECTION:
Visually inspect the
Avari GX8
to verify that assembly is as shown in the above illustration. Check the
function of the
Avari GX8.
Stand on the foot pedals and place your hands at a comfortable position on the
handlebars. Slowly move your highest foot forward and follow the natural path of the machine. Turn the
crank slowly through one complete revolution to verify that the drive train functions properly. Use the
"
Quick
Start
"
and
"
+/-
"
buttons on the
COMPUTER(20)
to select a program and verify that the Generator System
provides different tensions. Refer to the
COMPUTER INSTRUCTIONS
on pages 17 to 22.
Locate and read the
WARNING LABEL(95)
on the
Avari GX8.
Make sure that all users read
the
WARNING LABEL(95).
CAUTION:
To level the
Avari GX8,
first screw the
STAND(59)
located in
the middle of the
MAIN FRAME(1)
all the way up into the
MAIN FRAME(1)
so that it is not touching the floor.
Adjust the four
STANDS(59)
on each of the four
corners, two under
REAR STABILIZER(2)
and
two under the front of the
MAIN FRAME(1).
When all four are adjusted and the
Avari GX8
is stable, tighten the
NUTS(3/8"-16)
(79)
against
the
MAIN FRAME(1)
and
REAR STABILIZER(2)
to lock the
STANDS(59)
into position.
While you are adjusting these four
STANDS(59),
the one
STAND(59)
located in the middle of the
MAIN FRAME(1)
must not be in contact with the floor.
Only after the
Avari GX8
has been stabilized with
the four
STANDS(59)
on the corners will you
position the middle
STAND(59)
so it is in
contact with the floor to provide extra
stability for the
MAIN FRAME(1).
