Stamina 15-9200, Руководство пользователя

Страница: 13 / 22

13
STORAGE
1.
2.
3.
To store the CPS 9200 Indoor Cycle, simply keep it in a clean dry place.
Adjust the HANDLEBAR(2) and the SEAT POST(5) to the lowest position. Adjust the SEAT SLIDER(6)
to the most forward position. The CPS 9200 Indoor Cycle is approximately 40 3/4 inches long (min.) x
18 3/8 inches wide x 37 1/4 inches tall (min.). These dimensions will vary. Please measure your CPS
9200 Indoor Cycle if exact dimensions are needed.
To move the CPS 9200 Indoor Cycle, lift the REAR STABILIZER(4) and use the WHEELS(49) on the
FRONT STABILIZER(3).
MAINTENANCE
The safety and integrity designed into the CPS 9200 Indoor Cycle can only be maintained when the CPS
9200 Indoor Cycle is regularly examined for damage and wear. Special attention should be given to the
following:
Adjust the TENSION KNOB(34) and verify that the Flywheel System provides tension. The Flywheel
System should provide many years of use.
Use a wrench to verify that the pedals are tightened securely. If tightening is required, remember that the
left pedal has left hand threads and is tightened by turning counterclockwise. The right pedal has right
hand threads that are tightened by turning clockwise.
Verify that the
WARNING LABEL(70) is in place and easy to read. Call Stamina Products immediately at
1-800-375-7520 for a replacement WARNING LABEL(70) if it is missing or damaged.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components shall be replaced immediately or the
CPS 9200 Indoor Cycle removed
from service until repair is made.
Only Stamina Products supplied components shall be used to maintain/repair the
CPS 9200 Indoor
Cycle.
Keep your CPS 9200 Indoor Cycle clean by wiping it off with an absorbent cloth after use.
1.
2.
3.
4.
5.
6.
7.
OPERATIONAL INSTRUCTIONS
ADDING A FITNESS MONITOR OR METER
The CPS 9200 Indoor Cycle does not include a fitness
monitor or meter, but is equipped to add a fitness monitor
or meter if you wish. Fitness monitors can be purchased
at stores that sell biking accessories. Purchase a meter
that can be attached to the
HANDLEBAR(2), and follow
any installation and operation instructions provided by
the manufacturer. Your
CPS 9200 Indoor Cycle comes
equipped with MAGNET(73) built into the FLYWHEEL
(23), so it is not necessary to install the magnet that
comes with your meter; just attach the sensor to the
SENSOR CLIP(74) on the MAIN FRAME(1) and attach
the meter to the HANDLEBAR(2) following
manufacturers instructions.
NOTE: Some models of fitness monitors/meters may
not attach to the SENSOR CLIP(74). In this case, attach
the sensor to the MAIN FRAME(1) using the sensor
bracket provided by the manufacturer.
MONITOR/METER
(not included)
SENSOR
(Round bar type)