STALEX 388201, Руководство по эксплуатации

Страница: 10 / 25

10
Pressure: 0.20Kg/cm2 Type of fluid: Air
L. Angles Cutting:
1. Declination sawing: Loose table nuts; adjust the table into the desirable position,
and retighten the nuts.
2.
“R” shape sawing: Turn slowly because the sawing edge must remain flat, straight
and smooth.
3. Smaller working piece sawing: Be careful to push or pull the work piece by using a
wood block (not by hand); otherwise, the operator may get hurt.
4. Internal contour: First , drill a hole through the work piece large enough to fit the
blade through. Weld the blade ends together (grinding smooth). Reinstall blade on
wheels and make normal blade adjustment. Begin to perform contour sawing.
5. Working Speed: When sawing, the speed shall remain the same (neither fast nor
slow); otherwise, blade breaking may occur.
M. Safety and Maintenance:
1. Be sure that the safety cover and the wheel doors are always closed before turning
on the machine.
2. The band saw shall be installed in a dry place in order to avoid electrical shock.
3. Make sure the machine is grounded properly (green wire to ground).
4. After installing a new saw blade, start the motor and keep the blade turning without
load about 1 minute; then proceed to cutting the work piece
5. Upon sawing, if any unusual noise, smell or blade breakage occurs, operator should
immediately switch off the power.
6. Maintenance: After operating, switch the machine off. After clearing the machine,
take away the chips, and slightly lubricate the surface of the machine and all joints
to keep them from rusting.