STALEX 388201, Руководство по эксплуатации, Страница: 9 / 25

9
Trouble Possible Reason Solution
Blade do not
melt a. Blade two ends is not
straight and flat
b. Electrode is broken or worn.
c. Cut welding switch not work
d. Blade two ends do not
contact.
e. Blade clamping points have
rust.
a. Cut the two ends straight and flat.
b. Repair the electrode.
c. Polish the touch points of the switch
by sand cloth.
d. Re-cut the blade two ends.
e. Remove the rust by sand cloth.
Blade cannot
clamp tightly The distance between the
clamping roller and bottom bolt
is big.
Adjust the “adjusting screw” in the
clamping plate, to align the center of
clamping roller and the bottom bolt.
F. Grinder:
The grinder is used for grinding off both ends of the cut blade on the surface so that the
blade can be welded together easily. Note: Do not exceed in running the grinder for more
than 30 minutes at a time.
G. Blade Installation:
First turn off power and open the safety covers; then take off the old blade by turning the
blade tension hand wheel and removing the guide bar from the table. Replace the blade
with the teeth in the downward position. Be sure the safety covers have been closed.
H. Guide Rod Adjustment:
Adjustment to the guide rod is very essential. There are two rods: Top and Bottom. Only the
top one can be adjusted about 1mm above the sawing working piece. Note: If the
adjustment is made higher, the blade will be bent, so the support block of the supporting
blade should also be adjusted in line with the blade width and thickness. When making
adjustments, the power shall be shut off, and the support block shall be right in the middle
position of the rear of the blade teeth (neither loose nor tight).
I. Inverter Speed Selection and Operating:
J. See the Speed & Pitch selector on the front of your machine.
Operation method: Switch on; then turn motor starter switch on, and then adjust to
desirable speed by speed adjusting knob.
K. Air pump:
Voltage: 220V/60HZ Current: 0.5mA Flow rate:10-12(L/min)