6. Troubleshooting
Following are a few common problems that may occur and suggestions as to how to
solve them.
A. No light
1. Check the power on LED and fuse
2. Check the lamp if it is ok? (The lamp may turn off, when the unit is in
blackout).
B
.
Not responding to DMX
1. Check red LED is on, if not, check DMX connectors, cables and linking
correctly.
2. If the red LED is on and no response to the channel, check the dipswitch
settings and DMX polarity.
3. If you have intermittent DMX signal problems, check the pins on connectors or
on PCB of the unit or the previous one.
4. Try to use another DMX controller.
5. Check if the DMX cables run near or run alongside to high voltage cables that
may caused damage or interference to DMX interface circuit.
C. Some units don't respond to the controller
1. You may have a break in the DMX cabling. The unit receiving no DMX signal
will begin its own light show. Check the red LED for the response of the DMX
signal.
D. No response to the sound
1. Check the unit that is not receiving DMX signal (red LED should be off)
2. Check the unit that is not set to display mode
3. Check microphone to see if it is good by tapping the microphone
7. Fixture Cleaning
The cleaning of internal and external optical lenses and/or mirrors must be carried
out periodically to optimize light output. Cleaning frequency depends on the
environment in which the fixture operates: damp, smoky or particularly dirty
surrounding can cause greater accumulation of dirt on the unit's optics.
* Clean with soft cloth using normal glass cleaning products.
* Always dry the parts carefully.
* Clean the external optics at least once every 20 days. Clean the internal optics
at least every 30/60 days.
8. Technical Specifications
Power
230/240/250V 50/ 60Hz
Fuse
6,3 x 32mm, glass, T15A
Lamp
J Type 230V 500W
Dimension
450x270x175 mm
Weight
7 kg
e
n
g
lis
h
