3. Lamp
J Type 230V 500W
Always switch off the mains supply and never handle the lamp or luminaire when
it is hot.
Do not touch the bulb with bare hands. If this does happen, clean the lamp with denatured
alcohol and wipe with a lint free cloth before installing.
4. DMX Link & Controls
1. DMX output:
pin 1: Comm., pin 2: DMX
-
, pin 3: DMX
+
.
2. DMX input:
pin 1: comm., pin 2: DMX
-
, pin 3: DMX
+
. If you are using a controller with 5
pins DMX output, you will need to use a 5 to 3 pin adapter.
3. Dipswitch:
Dipswitch 1-9 set the DMX channel that the unit will respond to. Channel 1 is
the start address. Switch 10 sets the master/slave in 'group' of all the units. Please refer
to the diagram on setting the dipswitches.
4. Red LED: DMX signal / Sound activation.
This LED will flash when DMX signal is
being received or sound activation is working.
5. Built-in microphone for sound activation.
Connect the unit together in a 'daisy chain' by XLR plug from the output of the unit to the
input of the next unit. The cable can not be branched or split to a 'Y' cable. DMX512 is a
very high-speed signal. Inadequate or damaged cables solder joints or corroded
Connectors can easily distort the signal and shut down the system.
