Page 17
BUNGEE INSTALLATION
1. Insert 3 inches of one end of the bungee cord
through the eye of the termination clip then
push the bungee into the tapered slot below the
eye. Pass the remaining length of the bungee
through the open eyelet then back through the
eye to lock the bungee in place.
TECH TIP:
Remove the clip from the pulley axle
to aid in attaching the bungee.
2. Once one end of the bungee is secured to the
termination clip, pass it over then underneath
the first pulley (P1) on the opposite side.
P2
P3
P4
P1
3. Pass the bungee underneath and over the
top of the 2nd pulley (P2) located next to the
termination clip.
P2
P3
P4
P1
4. Pass the bungee over the top then underneath
the floating front pulley tensioner.
P3
P2
2
1
3
If the bungee becomes slack or needs replacement follow this procedure
to install or reinstall the bungee cord