Operating Instructions Industrial Box PC
Commissioning
Page 16 of 24
R. STAHL HMI Systems GmbH / OI_Industrial_Box_PC_en_V_01_00_00.docx / 26.09.2018
9.2.3.2
PS/2 keyboards
The Box PC will only recognise the PS/2 keyboard if it is connected with the Box PC
switched off, and then switched back on again.
Proceed as follows:
- Switch off the Box PC.
- Plug the keyboard cable plug into the PS/2 connector (9) of the Box PC.
- Switch the Box PC back on.
9.2.4
Mouse
You can connect a USB or a PS/2 mouse to the Box PC.
9.2.4.1
USB mouse
Plug the USB plug of the mouse cable into one of the 4 USB interfaces of the Box PC.
9.2.4.2
PS/2 mouse
The Box PC will only recognise the PS/2 mouse if it is connected with the Box PC
switched off, and then switched back on again.
Proceed as follows:
- Switch off the Box PC.
- Plug the mouse into the PS/2 connector (8) of the Box PC.
- Switch the Box PC back on.
9.2.5
Network LAN
Connect the power line to one of the two RJ45-LAN interfaces.
9.2.6
USB
A great variety of external devices (e.g. printer, scanner, modem) can be connected to the
USB interfaces.
USB devices can be hot-plugged. This means that the cables of USB devices can be
connected and disconnected to a Box PC even if it is switched on.
For more information, refer to the USB devices' documentation.
To ensure the transmission rate of USB 2.0, the cable between the external USB device
and the USB interface of your device must be no longer than 3 m.
Connect the USB cable to the external device.
Connect the USB cable to one of the USB interfaces of the Box PC.
9.2.7
Serial interface
The serial interface is for the connection of external serial devices.
Connect the data cable to the external device.
Connect the data cable to the serial interface of the Box PC.
9.2.8
Audio
Connect the line out devices to the audio out interface (10, bottom) of the Box PC.
Connect the line in devices to the audio in interface (10, top) of the Box PC.