Stahl G579/12, Руководство по эксплуатации

Страница: 7 / 12

212485 / 7579615300
2011-09-13·BA00·III·en·00
Putting into Service
7
SolConeX Plug
G579/12
 Strip the insulation from the cable (see figure).
 Connect the cable to the plug insert. The stripped cable ends must be pushed fully

underneath the clamping plate.
 Align the cable such that the clamping points are not under strain.
 Mount the strain relief (D).
 Fasten the plug insert in the enclosure such that key and guiding groove (E) match.
 Press the seal into the enclosure.
 Place the pressure ring on the seal.
 Tighten the pressure screw (B).
 Secure the pressure screw with the clamp (C).
12 Putting into Service
Before putting into service

Make sure that the components are not damaged.

Make sure that the device has been installed correctly.

Remove any foreign objects from the device.

Check if cable glands and stopping plugs are tight.

Check if screws and nuts are fastened tightly.

Inspect the cable glands for signs of damage.

Check the tightening torques.

Make sure that the bayonet lock is tightened correctly.
09290T00

On the connection side, the contact pin carrier is marked with "Abisolation"
(insulation stripped) next to the protective conductor connection symbol.

The indentation below indicates the correct stripping length.
WARNING
 The plug may only be used when fully mounted.
 The plug pin surface must not be damaged.
 Excessive tightening of the components can impair the degree of protection.
a
[mm] b
[mm]
80 17