243137 / 640260300020
2015-12-22·BA00·III·en·05
Mounting and installation
17
Linear Luminaire with LED
Series EXLUX 6402/2
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
EN
Note:
• Version without switch: Disconnect the luminaire from the power supply and secure
it against being switched on again.
• Version with switch: The luminaire is positively disconnected from the power supply
by actuating the central lock.
• In open end position and with translucent cover swivelled down, a restart lock-out
device prevents the central lock from being actuated.
Please do not use force!
When the translucent cover is closed, the central lock is released.
Opening and closing the reflector plate
7.3.2 Electrical connections
Electrical connection
Observe the maximum clamping possibility of the connecting terminals (see chapter
"Technical data").
For optional screw-type terminals, two conductors per clamping unit can be clamped
(ingoing and outgoing wiring).
Note:
• Clamping must be carried out precisely!
• Do not clamp any part of the conductor insulation!
• Do not interchange the conductors!
• Observe the technical regulations when connecting the conductor!
• Clamp the conductor firmly.
• The terminal cover of optional screw-type terminals does not have to be removed
to clamp the conductor!
• Optional screw-type terminals: Firmly tighten screws (tightening torque 2 Nm,
for unused clamping units 0.7 Nm)!
Connection terminals
15512E00
1 Open the reflector plate by
pressing the safety latch.
2 Swivel down the reflector plate.
• When closing, flip up the
reflector plate and snap it into
place.
1
2
