Stahl 9478 Series, Руководство пользователя

Страница: 10 / 15

Digital Output Module Valve Series 9478
4
201
5
- -0 ·BA00·III·en·0 205343 / 947860310010 www.stahl.de
2
perating Instructions for the IS1 system
IS1 I/O-Modules
LED Indications and Troubleshooting
LED
green
"RUN" LED red
"ERR I/O Module status Source of fault Possible troubleshooting solution
On Off All signals are OK none --
On Blinks Signal diagnosis Fault on internal electrical
connection to solenoid valve. Replace the I/O module.
On On Outputs are in safety position Plug-in terminal X2 is not
connected. Connect plug-in terminal X2.
Blinks Off In standby (switched on but no
data exchange with master
yet) • The module is in proper condi-
tion but is not ready for cyclic
data exchange yet (there is no
parameter set available yet).
• The outputs are inactive.
Activate the cyclic data transfer with
the master.
Check the master, bus connection
and CPM.
Blinks Blinks Data Exchange has been quit
(the outputs are in safety
position) Cyclic data transfer with master is in-
terrupted. Activate the cyclic data transfer with
the master.
Check the master, bus connection
and CPM.
Blinks On Configuration fault Configuration is not correct or a
false module is connected. Change configuration of master or
connect to the right module.
Off On or
blinks I/O module hardware fault • Hardware check fault
• Eprom fault
• EEprom fault
Replace the I/O module.
Off Off Off No supply voltage at the I/O module
or defective I/O module. • Check the power supply of the
CPM.
• Check the CPM.
• Check the BusRail.
• Engage the I/O module correctly
on the BusRail.
• Replace the I/O module.
Note
Contact the responsible sales subsidiary or our service department (support.instrumentation@stahl.de) if the fault cannot
be eliminated using available troubleshooting options.
Explosion Protection
Certificates
Europe (ATEX) PTB 10 ATEX 2030
IECEx IECEx PTB 06.0001X
Marking
Europe (ATEX) E II 2 G Ex ib IIC T4
Gb
IECEx Ex ib IIC T4
Safety data for digital input (ATEX)
for disconnecting all outputs ("System OFF")
Ex ia
The effective internal capacitances and inductances are negligible.
Further information see respective certificate
U
0
[V] I
0
[mA] P
0
[mW) L
0
[mH] C
0
[nF]
IIC IIB IIC IIB
6.6 67 110 8.24 31.4 22 500