ST315B User Handbook
Page
7
When the ST315B is not firing there are no lamps lit on the mimic panel,
the run lamp is off and the display shows the kiln temperature with the °C
indicator lit.
Altering a program
.
°C
°C/hr
hr.min
If the left
-
hand decimal point is on
then the keyboard is locked. Press
the
&
keys together & hold
down for 5 seconds to unlock.
The controller settings can be reviewed by pressing the
key.
The first push of the
key flashes
the program number display. This
can be altered from 1 to 9 with the
&
keys.
Note: holding down the
or
keys causes rapid change of the displayed value.
.
°C
°C/hr
hr.min
The next push of the
key displays the start
delay time in the range 00.00 to 99.59 (99
hours 59 mins). This can be altered with the
&
keys. The DELAYED START lamp
on the mimic display will flash.
°C
°C/hr
hr.min
then displays the ramp rate in the range 1
to 999°C/hr or
or
. This can be
altered with the
&
keys. The
HEATING RAMP or COOLING RAMP
lamp on the mimic display will flash.
°C
°C/hr
hr.min
then displays the soak temperature in the
range 0 to 1400°C. This can be altered with the
&
keys. The SOAK TEMPERATURE
lamp on the mimic display will flash.
Pr
ogram
ming
PROGRAM
.
°C
°C/hr
hr.min
The next push of the
key displays the
soak time in the range 00.00 to 99.59 (99
hours 59 mins). This can be altered with
the
&
keys. The SOAK TIME lamp
on the mimic display will flash.
A further push of the
key increments the
segment display digit and firing data for the
next segment can be entered.
SEGMENT
