P a g e |
22
P a g e |
Fuse located inside
of down tube
◀
2. Determine if brake cable has too much
slack or brake hub is dragging on the brake
pad:
a. Loosen brake hub barrel adjuster.
b. Adjust brake hub adjuster in or out
until desired brake adjustment is at-
tained.
c. Lock brake hub barrel adjuster.
d. Perform final adjustment of tension in
brake cable with brake lever barrel adjuster.
e. Repeat “Test Brake” section above.
Replace Fuse:
WARNING: Motor and Electronic Speed Controller (ESC) can be very hot and cause
burns. It is critical that the cycle is allowed to cool prior to accessing motor and ESC.
WARNING: To prevent shock, follow the instructions and do not skip any steps.
1. Place power switch in “OFF” position.
2. Remove battery from cycle.
3. Remove foot platform.
4. Remove right side panel, allow motor and Electronic Speed Controller adequate
time to cool before you proceed.
5. Locate fuse. Remove the fuse from socket. Verify that replacement fuse is the
specified amperage. Replace fuse.
6. Re-Install right side panel.
7. Install the foot platform.
Chain Tensioner
Bolt to secure brake hub
◀
◀
Replace Chain:
