P a g e |
20
P a g e |
CHECK AND MAINTAIN CYCLE:
Before use, check to confirm that the cycle is in proper working order. The cycle
should be maintained and repaired in accordance with the manufacturer’s specifica-
tions, using only the manufacturer’s authorized replacement parts, and should not be
modified from the manufacturer’s original design and configuration
REPAIR AND MAINTENANCE:
Tools Required:
• 2.5, 4, 5, 6 mm Allen Wrench
• 8, 10, 15 mm socket or open end/box end wrench
• #2 Phillips screw driver or T-10 Torx driver
Turn power switch to “OFF” position, remove battery, allow cycle to cool before
beginning repair or maintenance:
• Read instructions.
• Ensure the power switch is “OFF”.
• Ensure the battery is removed and cycle has had adequate time to cool. (up to 30
minutes)
• Secure the cycle for repair or maintenance.
• Exercise caution around exposed parts.
• Contact customer service if unsure about any repair or maintenance.
Replacement Parts:
For the complete selection of replacement parts visit www.STACYC.com.
Repair Centers:
For a list of authorized service centers visit www.STACYC.com.
Test Brake:
1. Squeeze brake lever and hold.
2. Push cycle forward. The rear wheel should not spin if brake is adjusted properly.
3. If rear wheel spins when pushed forward or brake lever engages prematurely,
refer to “Adjust Brake”.
Brake Lever barrel adjuster
Brake Hub barrel adjuster
◀
◀
