Assemble the tactical gun rests in the center
compartment. You may want to elevate the guns on
a shelf as shown. Determine the height of the gun
rest and assemble to the brackets as shown.
Position the adjustable stock rest to support your
tactical guns as shown.
TACTICAL GUN REST ASSEMBLY
Lower the gun rest so the back of the rest is flush
with the wall bracket. Secure the gun rest to the
wall bracket with one of the screws supplied.
Slightly angle the barrel rest upward and hook the
tab into the wall bracket as shown.
SECURING THE SAFE
1
Secure the safe with the fasteners and replace the
carpeting.
Use these holes to fasten the safe to the floor. Drill
the appropriate diameter and depth of pilot holes
into the floor depending on the type of hardware
being used and the type of floor surface. (Figure 2)
You must remove the safe from the skid/legs and
place the safe on the floor. Place the safe in the
desired location. When you open your safe, lift the
bottom carpeting up to find the two hole locations
marked on the floor insulation. Drill holes through
the insulation using the same diameter drill as the
diameter of the mounting hardware you are using.
IMPORTANT: The fasteners you use must
completely fill the hole you drilled into the
insulation. (Figure 1) You must use the fasteners
after you drill the holes. Failure to do so will void the
fire rating.
2
NOTE: The safe must be secured to the floor.
Use the hardware provided or consult your
hardware retailer for fastening hardware for your
particular mounting surface.
NOTE: This safe must be mounted to the floor.
Failure to do so will compromise the safety and
security of the safe.
40356-1409
4
21
