GETTING STARTED
INSTALLING THE BATTERY
When you first receive your safe you will need to
open the door with the key in order to install. A
battery is included and is located in the top of
the Styrofoam packaging.
To open the safe, insert key into lock and turn
counter clockwise until the holster
compartment automatically opens.
To access the battery compartment you will
need to open the holster compartment
completely.
At the very back of the compartment you will
see two L shaped brackets. Rotate the L
brackets towards the top of the safe, so they are
released from the guides Then squeeze the two
brackets together so they almost meet - this will
immediately release the compartment from the
sides of the safe body as shown in figure 1. Let
the holster compartment open all the way.
Rotate the L brackets back so they are flat
against the back of the holster compartment as
shown in figure 2.
NOTE: Leave the key in the lock while you
install the batteries.
This safe uses 4 AAA alkaline batteries. Under
normal use the batteries will last about a year.
NOTE: If the batteries are low the indicator light
will flash blue when you start scanning. Replace
with 4 new AAA alkaline batteries as shown.
Locate the battery compartment at the very
back of the top of the safe, slide off the battery
cover.
40667-1512
2 15
Inside safe
Battery
NOTE: This key has also be provided in case
the batteries run low. If you lose your key,
you may purchase a replacement key by
referencing the serial number located on the
front of the door. See section regarding
replacement keys for further information.
Battery Cover
4
1
