CLOSING THE SAFE
Lift up the up the holster compartment until
the L shaped brackets clear the inside of the
frame. Rotate the L bracket back so they point
to the top of the safe and then push them out
towards the safe body which will hold the
holster compartment up. Then rotate the L
brackets back into the guides on the back of the
holster compartment.
Close the compartment and hold it closed
until the green light goes on and the unit
beeps.
NOTE: Reset button is only
accessible when the locking
mechanism is in the un-locked
position.
NOTE: To verify your fingerprint the
locking mechanism must be in the
locked position.
NOTE: When closing the safe with a pistol in the
holster compartment, make sure the pistol does
not interfere with the frame of the safe.
40667-1512
3 15
Inside safe
Reset Button
3
Inside safe
RECORDING FINGERPRINTS
When you first receive your safe there are no
recorded fingerprints. For security you must
record a fingerprint. Failure to do so will
compromise the safety and security of the safe.
You can record up to 20 different fingerprints
for opening the safe.
To record a fingerprint, first press the Reset Button on
the inside of the safe. The scanner will turn blue with
two beeps (if the sound is turned on) and the blue
light flashes twice, you will then record the same
finger three times as follows:
1. Press the scanner with the selected finger
until there is one beep (if the sound is turned
on) and the green light flashes once. Lift your
finger off the scanner.
2. Press the scanner for a second time with the
same finger (holding the finger in a slightly
different position) until there is one beep (if
the sound is turned on) and the green light
flashes once. Lift your finger off the scanner.
3. Press the scanner for a third time with the
same finger (holding the finger in a slightly
different position) until there are two beeps (if
the sound is turned on) and the green light
flashes twice. Lift your finger off the scanner.
If the red light flashes three times with three
beeps (if the sound is turned on) your fingerprint
did not get recorded and you will have to start
over.
Your fingerprint is now recorded.
If you try entering more than 20 fingerprints, the
red light will flash 5 times and there will be 5
beeps (if the sound is turned on).
For convenience, record several different fingers
and record the most used finger several times.
Position finger on scanner as shown below.
