ELECTRONIC LOCK
BATTERY INSTALLATION
You must first install the battery which is located in
the front protective styrofoam.
NOTE: When changing the battery, always hold
the battery connecting cap while disconnecting or
attaching the battery. Do not pull on the wires.
Doing this could cause the power supply to become
disconnected from the lock.
This safe uses one 9V alkaline battery. Under normal
use the battery will last about 1 year.
When the battery is low and you press a button on
the keypad, a red light will come on warning you
that the battery is low.
To replace the battery, remove the cover by pressing
the tab and turning the cover as shown in the
illustration below. Replace the old battery and screw
the cover back in place.
After installing the battery, to open an electronic lock
the first time, press the following numbers/symbols
on the electronic keypad in this order:
1 - 5 - 9 - #
.
These numbers are preset.
NOTE: You should change the entry code as soon
as possible after opening the safe to insure proper
security.
After you have entered the factory code, you will
need to turn the handle clockwise to open the door.
You will have 5 seconds to turn the handle before the
locking mechanism is reactivated.
TAB
NOTE: The red reset button located on the
inside of the door, is covered with a removable
red cap. When you use the red reset button
while setting your own combination, remove
the cap to access the button.
Replace the cap securely over the reset button
after setting your combination. Failure to do
so will compromise the safety and security of
the safe.
40529-1504
2
24
