23
Instructions for installation
For some time, the automobile manufacturers have specified the
positions in and on the motor vehicles at which the radio sets
and its antennas may be mounted.
On the one hand, this is done to protect you from excessive field
intensities inside your motor vehicle, on the other hand to avoid
malfunctions of the electronic system in the car due to radiation.
In any case, you should observe these specifications, since the
type approval of your vehicle can expire otherwise.
Thus, contact your automobile dealer for the corresponding ma-
nufacturer specifications belonging to your car model.
Installation
Installation in the motor vehicle
a)
Please consider the instructions of your automobile manufacturer.
b)
Make sure that all cables and connecting lines are laid in the
motor vehicle without any problems such that the vehicle operation
is not impaired. Do not install the cables near the heating system!
c)
For installing your radio set at the appropriate position, use the
mounting device (1) and the tapping screws (2) (drill hole diameter:
3.2 mm). Prior to drilling, make sure not to damage any cables of
the electric system in the car! The mounting device should be
installed at an appropriate place providing a rigid, reliable and
almost vibrationless positioning of the radio set.
d) Choose a place for the microphone attachment such that the
microphone is always within reach. Remember that its microphone
cord must not interfere with the control elements of the vehicle.
Choosing your antenna:
The following applies to CB radio as well: The better the antenna
quality, the greater the range of the radio set.
Make the appropriate choice according to the following recommen-
dations!
