HOLD= Hold
o
Explanation:
This function works well if you are in an awkward
position or cannot see the LCD screen. It is also handy to lock in
an important measurement on the screen until it is convenient
to write it down or cut your material.
o
How to Use:
Move your Electronic level into the position that is
needed and press the HOLD button. At this time the
measurement that you are measuring stays on your LCD screen.
The arrows on each side of the digital readout blink in this
function to remind you that you are in the HOLD function not
level.
Auto Shut-off
o
Explanation:
In order to conserve on battery life, we have built
in an automatic shut off function into the electronic module.
The factory preset for the module is 10 minutes after the last
movement. Should you find the need to extend the auto shut-
off time; the module can be adjusted to automatically shut off
after 2 hours.
o
How to Use:
If the module is set in the 10 minute auto shut-
off mode, there will be no symbol displayed on the LCD screen.
To switch the module over to the 2 hour auto shut-off, simply
push the sound button and the hold button simultaneously.
When the module is switched into the 2 hour mode, there will
be a symbol of a clock in the lower right hand corner of the
screen. To change the auto shut-off back to 10 minutes, simply
repeat the step of pushing the sound and hold button at the
same time.
www.
GlobalTestSupply
.com
Find Quality Products Online at:
