STA-RITE IntelliPro Variable Speed, Инструкция по установке и эксплуатации

Страница: 9 / 52

Two Speed Pump Controls Notice California (Title 20 Compliance)
Please read the following important Safety Instructions. When using two-speed pumps manufactured
on or after January 1, 2008, the pump’s default circulation speed MUST be set to the LOWEST
SPEED, with a high speed override capability being for a temporary period not to exceed one
normal cycle, or two hours, whichever is less.
Pentair Water Pool and Spa ®
PUMP WARNING AND SAFETY INSTRUCTIONS
For Pool and Spa Pumps (Non SVRS Pumps)
(Pentair Water Pool and Spa
®
, Sta-Rite
®
, and Pentair Pool Products
®
)
General Warnings, (Continued).
• Never open the inside of the drive motor enclosure. There is a capacitor bank that holds a 230
VAC charge even when there is no power to the unit.
• The pump is not submersible.
• The pump is capable of high fl ow rates; use caution when installing and programming to limit
pumps performance potential with old or questionable equipment.
• Code requirements for the electrical connection differ from state to state. Install equipment in
accordance with the National Electrical Code and all applicable local codes and ordinances.
• Before servicing the pump; press the Stop button and disconnect the communication cable,
then switch OFF power to the pump by disconnecting the main circuit to the pump.
• This appliance is not intended for use by persons (including children) of reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning the use of the appliance by a person responsible
for their safety.
• To reduce the risk of injury, do not permit children to use this product unless they are closely
supervised at all times.
SAVE THESE INSTRUCTIONS
vii
IntelliPro
®
Variable Speed Pump Installation and User’s Guide