3
2. If not already done, attach the Bumper and Roller to
the flexible stalk protruding from the body of the
Calypso (See Figure 1A).
3. Attach the Pipe and Nut Assembly to the top (threaded)
end of the Calypso (See Figure 2A).
First place the collar of the Bumper and Roller assembly
over the threaded end of the Main Housing and then screw
on the Pipe and Nut Assembly as shown in Figure 2B.
When the Pipe and Nut Assembly is installed, the bumper
and roller won’t swing loosely from the cleaner.
Hand tighten
the nut as if you were tightening the lid on a
kitchen container; you will occasionally need to unscrew
the Pipe and Nut Assembly to perform routine mainte-
nance on the cleaner.
Your Calypso cleaner is assembled!
Figure 2B
Figure 2A
Figure 1A - Cleaner body with
round vacuum plate attached
and Bumper/Roller attached.
Figure 1F - Hose Sections
(each section has one male
and one female end).
Figure 1L - Flow Gauge.
Figure 1E - Outlet Diverters.
Figure 1D - Bumper and Roller
(This may already be attached
to the cleaner body).
Figure 1C - Regulator Valve
and Cap.
Figure 1G - Adapter Cone.
Figure 1H - Hose Weight.
Figure 1J - Ladder Deflector.
Vac
Port
Figure 1K - Vac Port Fitting.
Figure 1B - Pipe and Nut
Assembly (to attach to the
cleaner).
