ST Micro Connect 2
Connectors
7912386 Rev 12
39/58
A.5
VHDCI LVDS host interface
This port can be can be connected, using an SCSI-V VHDCI cable, to:
●
a Type A STMC I/O convertor
●
a Type C STMC I/O convertor
●
a Type H STMC I/O convertor
●
a target with a Type F pinout (LVDS convertor on the ST evaluation board)
●
a target with a Type G pinout (LVDS convertor on the ST evaluation board)
●
a target with a Type K pinout (LVDS convertor on the ST evaluation board)
The pinouts are described in the
ST system-on-chip (SoC) debug interfaces technical note
(8339250).
Further information about connecting to the target is given in
Appendix B: Target interface
on page 40
.
Figure 11. VHDCI 68-pin micro-D (high density, SCSI-V female port)
A.6 Power
supply
The ST Micro Connect 2 uses a lump-in-cord power supply pro5 V DC. All other
required voltages are provided by on-board voltage regulators.
Figure 12. DC 5 V power connector
1
35
68
34
On front panel
DC IN
0 V
+5 V
On rear panel
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
