ST Micro Connect 2
Introduction
7912386 Rev 12
11/58
1.2 System
interface
The ST Micro Connect 2 can operate in conjunction with the following STMicroelectronics
software products:
●
ST20 Embedded Toolset R2.3.1 and later
●
ST40 Micro Toolset R4.0.2 and later
●
ST200 Micro Toolset R6.1 and later
●
STxP70 Toolset R3.3.0 and later
●
STLinux 2.2 and later
●
STAPI SDK 0.7.0 and later
For details of the latest product availability please contact your ST FAE or ST support
centre.
1.3
ST Micro Connect 2 power up
On power up or reboot the ST Micro Connect 2 goes through the following sequence.
The
PWR
LED illuminates when power is applied and the LEDs on the ST Micro Connect 2
front panel are illuminated in the following order: ACTIVE, CONNECT, ERROR. The LEDs
then cycle for a few seconds to indicate that the ST Micro Connect 2 software is running. For
a description of the status LEDs, see
Appendix C: LEDs on page 43
.
On boot-up, the LCD displays a ready message and then cycles the
Status and
configuration display
, see
Chapter 2: LCD interface on page 13
.
Figure 3.
ST Micro Connect 2 front panel
1.4 Compliance
statement
Please refer to
Appendix F on page 49
for details of CE compliancy, warnings and safety
critical information and end-of-life disposal instructions.
Power
Power
VHDCI - LVDS connector
Status
LEDs
Select
button
Next
button
LED
button
ST MICRO CONNECT 2
®
ERROR
CONNECT
ACTIVE
NEXT
SELECT
TARGET
POWER
LCD
LCD
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
