DocID022136 Rev 5
7/67
UM1460
Hardware layout and configuration
66
1.4 Delivery
recommendations
Several verifications are needed before using the board for the first time to make sure that
nothing has been damaged during shipment and no component is unplugged and lost.
When the board is extracted from its plastic bag, please check that no component remains
in the bag. Main components to verify are:
1.
The 25 MHz crystals (X1 and X4) may have been removed by a shock.
2. The camera connected on socket CN15 located on the right side of the board under the
JTAG connector may be unplugged. If this is the case, please refer to the note in
Section 2.18: Camera module
to make sure to plug it in the correct position.
3. The microSD card may have been ejected from its connector CN6 (top left corner of the
board).
The plastic protection on the camera should be removed carefully as the connection is very
fragile.
2
Hardware layout and configuration
The STM3241G-EVAL evaluation board is designed around the STM32F417IGH6 in a
UFBGA176 package.
The hardware block diagram
Figure 2
illustrates the connections between the
STM32F417IGH6 and peripherals (camera module, LCD, SRAM, EEPROM, ST MEMS,
USART, IrDA up to version C07 of the board, USB-OTG HS, USB-OTG FS, Ethernet, Audio,
CAN bus, smartcard, microSD card and motor control).
Figure 3
locates these features on the board.
Note that for every figure (layouts and schematics) of this user manual, whenever IrDA is
indicated, it is only significant for board version up to C07, since IrDA has not been
populated on later versions of the boards (so IrDA is not present from the C08 board
onwards).
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
