Device overview
STA382BW
Doc ID 022783 Rev 1
4.3.1 STC
block
diagram
Figure 8.
STCompressor
TM
block diagram
The STC takes as input 2 channels and every channel is processed independently (i.e. an
independent DRC for each band of each channel) following the steps listed below
(
1.
Splits the input signal into 2 bands (band splitter)
2.
Measures the level of the signal (level meter)
3.
Computes the attenuation (mapper)
4.
Applies the attenuation and offset (attenuator)
The band splitter settings are common to both the processing channels while the settings of
the remaining blocks can be independently set for each band of each processing channel.
Caution:
All the settings explained hereafter apply only to the behavior of the STCompressor
TM
. For
the settings concerning other device operating configurations (see
) please refer to the appropriate paragraphs and registers.
4.3.2 Band
splitter
The band splitter block is used to divide the signal into 2 sub-bands (typically low- and high-
frequency bands). This is done through two 2
nd
order biquads (IIR filters) for each band,
thus allowing to have up to a 4
th
order filter per band. This feature guarantees a totally flat
). Using different filtering orders, indeed, causes a non-
negligible gain around the filter’s cutoff frequency, endangering the overall audio fidelity and,
eventually, also the safety of the speaker. The sub-band recombination can be enabled or
disabled.
Level
Meter
M
a
p p er
Atten
ua
to r
O ff
s
et
X
Level
Meter
M
a
p p er
Atten
ua
to r
X
O ff
s
et
+
B
a
n d
S
p litter
B
a
n d 0
(Lo w fre
q s
)
B
a
n d 1
(Hig h fre
q s
)
In p
u
t
Ch 0
O
u
tp
u
t
Ch 0
DRC 0
DRC 1
Lev el
Meter
M
a
p p er
Atten
ua
to r
O ff
s
et
X
Lev el
Meter
M
a
p p er
Atten
ua
to r
X
O ff
s
et
+
B
a
n d
S
p litter
B
a
n d 0
(Lo w fre
q s
)
B
a
n d 1
(Hig h fre
q s
)
In p
u
t
Ch 1
O
u
tp
u
t
Ch 1
DRC 2
DRC
3
