LIT-237
CUDA
®
Surgical
Rev. E
(English)
Page 5 of 73
3.
OPERATION
Before continuing remove the protective lens cap from the headlight module.
Insert a fully charged battery into the battery compartment module located on the left side
of the headlight when in use. To do so, line up the battery rails located in the compartment
with the slots located on the sides of the battery
pack. Push battery into the housing then
slide forward toward the contacts until the locking tab clicks into place. See figures 1, 2,
and 3 for further detail. To remove the battery pack from the battery compartment, press
down on the locking tab, and perform the reverse of the above operations. While pressing
down on the locking tab, slide the battery pack back and pull straight out.
FIGURE 1 (above). Inserting the battery pack
FIGURE 2 (right).Fully inserted battery pack
FIGURE 3 (left).Control Module
1. Intensity Knob and Power Switch
2. Green LED battery gauge
Once the battery is installed, turn the unit on by turning the intensity control knob
clockwise. The intensity control knob will click to signify turn-on and turn-off. Adjust the
intensity control until the desired brightness is achieved. Note that less intense brightness
settings can produce longer runtimes.
Located next to the intensity control is the battery gauge consisting of three small green
LEDs. Each LED tile represents approximately 30% of battery charge. Refer to Table 1
