Ashby-MF Insert
31
Program 3.
The Cycle Time is 11.5 seconds. THIS PROGRAM IS ONLY TO BE USED WITH
THE ASHBY-P MODEL.
(DO NOT USE THIS PROGRAM WITH THE ASHBY-MF).
Program 4.
The Cycle Time is 10 seconds. THIS PROGRAM IS ONLY TO BE USED WITH
THE ASHBY-P MODEL.
(DO NOT USE THIS PROGRAM WITH THE ASHBY-MF).
Changing the program on the Control Board
To change the program the Insert must be in the OFF
position, the unit must be cooled down so the Proof of Fire
disc is open and the Thermostat Slide Switch must be in the
Manual mode.
(See figure 18)
Press & hold
the Auger Feed Button, then press the Trim
High & Low
Button at the same time. The 5 LED lights that
indicate the heat levels will flash. The number of times the
lights Flash will indicate which program is running.
Program 1 – LED lights flash
once
Program 2 – LED lights flash
twice
Program 3 –LED lights flash
three times
Program 4 – LED lights flash
four times
Figure 18
Lighting Your Stove in the Multi-Fuel Burn Pot.
WARNING: - Risk of Fire.
-Do not operate with the Firebox door or Ash Removal doors open
-Do not store Fuel or other Combustible material within marked Installation Clearances.
-Inspect and Clean Flues and Chimneys regularly.
Danger: Risk of Fire or Explosion - Do not burn Garbage, Gasoline, Drain Oil or other
Flammable Liquids.
WARNING: Do not bypass the hopper lid switch. The auger can start at any time while the
Stove is running
,
this is a high torque motor that is capable of doing SERIOUS harm to
fingers. Keep fingers and other objects away from the auger.
When lighting your Stove for the first time the auger tube will be empty, it helps to hold the
Auger Button in until you hear fuel drop into the burn pot.
1. Make sure there is corn in the hopper.
