SST SST-ASI-SLC, Руководство пользователя

Страница: 59 / 74

Troubleshooting
53
NOTE: SLC Fault Codes can be read from the SLC processor using
Allen-Bradley’s APS or equivalent software.
9.2 AS-i Power Failure
In the event of an AS-i power failure, scanning of the AS-i network stops and
the slave outputs turn off. The SLC faults with code 61h. Refer to the table in
section 9.1. To return the SLC to run mode, correct the power fault and switch
from program to run mode.
Any Flashing
Green A slave on the network
has failed or is missing. Check that the G file is
not in error. If the G file
is OK, check the
network setup for
missing slave.
If Auto Address
Programming is
enabled, replace the
missing slave with a
matching slave at
address 0. Go to
Config mode and
perform a list
command. 62h
Off Green Scanner is operating
properly. All OK. N/A
Red Both Red Software error on
scanner. Call SST Technical
support with a
description of the
circumstances that
caused this error. N/A
FAULT
LED
COMM
LEDs
Description Troubleshooting SLC
Fault
Code