SST Automation GS11-MT, Руководство пользователя

Страница: 19 / 58

www.sstcomm.com
19
12
Default Gateway Address, high-byte first
13
14
15
16 Reserved, always 0
17 Reserved, always 0
18 Reserved, always 0
19 Check sum, byte 0+byte 1+…+byte 18
2. Response message--- (module->user board)
byte Correct Response Incorrect Response
0 Data length is 2 Data length is 2
1 0: Correct Error code (not 0)
2 0 Extra error code
3 Check sum, byte 0+byte 1+byte 2 Check sum, byte 0+byte 1+byte 2
3. Error code
Index Error Code Explanation
0 1 Check sum error.
1 2 Data length error.
2 3 IP configuration mode does not exist.
4. Extra error code is always 0xFF
GS11-MT also has sending IP address reporting function (via UART).To enable the function, you must meet
the following two conditions: 1. The module is set to DHCP; 2. In the above request message table, the Byte 2 is
set to 0x01; After the user transmits the setting IP address message, the user will receive "0x2E" per second, until
the GS11-MT successfully obtain an IP address. Then the user will receive a message, and its format is shown as
follows:
IP Address Report