SSS Siedle KA/WG 950-0 C, Руководство пользователя

Страница: 8 / 34

6
English
Mounting
Application
The colour CCD video camera is
suitable for mounting in outdoor
locations. It is weather protected,
has a sun shade and a thermo-
statically controlled heating system.
Plinth housing with ball head and
internal wiring. The connecting
cables for supply and the coaxial
conductor are mounted ready for
plug-in connection; appr. 10 cm
long. The camera comes with
fastening material and an Allen key.
It is possible to set the zoom and
focus using buttons directly at the
camera.
Electrical voltage
Mounting, installation and
servicing work on electrical
devices may only be performed
by a suitably qualified electrician.
• Please read through this product
information carefully before
commissioning the camera.
• Never operate the camera outside
the specified limiting temperature,
humidity or voltage values.
• When laying the connecting cable,
ensure that it is not subject to load,
kinked or damaged in any way.
The following installation situations
must be avoided without fail:
• Direct backlight
• Direct sunlight
• Very bright picture background
• Highly reflective walls opposite the
camera
• Luminaires or direct light sources
within the camera's field of vision
Electrostatic charging
Electrostatic charging can cause
irreparable damage to the circuit
board as a result of direct contact.
For this reason, direct contact with
the circuit board must be avoided.
Scope of supply
• KA/WG 950-...
• 3 recessed head screws 5 x 50
• 3 wall plugs D = 6 mm
• Allen key size 3
• Cable strain relief with two screws
• 8 sealing plugs
• This product information
Mounting
1 - Remove the sunshade.
- Remove the fastening screws of
the mounting plinth.
- Fix the mounting plinth on the
wall. Use the supplied drilling
template on the fold-out page.
- Connect the supply line and coaxial
cable of the house installation at the
6-pin plug-connector of the camera
and stow any surplus length of the
connecting cable in the plinth
housing. Fasten the installation cable
at the camera foot using the cable
strain relief.
2 Place the camera on the mounting
plinth, apply the fastening screws
using moderate pressure and
tighten.
3 Release the relevant fastening
screws, align the camera with the
surveillance area and fix.
Setting the zoom and focusing
4 By screwing in the grub screws,
open the camera housing (turning to
the right) and remove the protective
housing.
5 Using the buttons at the back of
the camera, set the zoom and focus.
These settings can be executed
directly at the camera.
a) TELE/WIDE
Setting the optical zoom area
b) FAR/NEAR Setting the focus
c) MENU Selection of menu
functions in the OSD display
d) BNC connection, video signal
1Vss
e) RS485 interface for actuation via
the PC
Other settings
Other camera settings can be carried
out using an OSD (On-Screen-
Display) menu. To carry out these
settings, the video signal of the
camera must be connected to a
monitor. The camera menu can be
seen on the monitor. The menu
points with setting facility are shown
on the next two pages.
6 Close the housing, screw back
together and push the sunshade
over the camera housing. The visible
Allen screws can be covered using
the provided sealing plugs.
Terminal assignment
Black = - supply
Red = + supply
20 - 30 V DC
Brown/
Orange
= Lb, Hz
Supply for the
heating 12V AC
Coaxial = S/L
Shield/Conductor