48
Accelerator Damper™ Service
Clamp the cartridge tube into a bicycle stand with the bypass hole oriented
downward.
Pinch the glide ring closed against the piston, then thread the seal head
and rebound assembly into the cartridge tube.
While holding the cartridge tube in place, thread the damper seal head into
the cartridge tube and tighten the rebound assembly.
Remove the cartridge tube assembly from the bicycle stand, turn it over, and
clamp the cartridge tube assembly into the bicycle stand so the rebound
shaft is oriented downward.
Pull down on the rebound shaft.
15
16
17
22 mm
12.4 N·m (110 in-lb)
Wrench
18
Содержание RockShox RS-1
Страница 1: ...GEN 0000000005735 Rev A 2018 SRAM LLC 2015 2019 RS 1 s e r v i c e m a n u a l ...
Страница 32: ...32 Bleed Procedure Remove the damper anchor o ring Apply grease and install a new o ring RLC RL remote 16 ...
Страница 43: ...43 Accelerator Damper Removal Remove the bottom cap o ring Apply grease and install a new o ring 11 ...