SRAM RockShox RS-1, Руководство по обслуживанию

Страница: 50 / 59

50 Accelerator Damper™ Service
Slowly push the rebound shaft into the cartridge tube until there is about
50 mm of shaft exposed.
Slowly insert the compression damper into the cartridge tube while gently
rocking the compression damper side to side.
Thread the compression damper into the cartridge tube.
The rebound shaft will extend downward as you insert the
compression damper.
Thread the damper anchor into the cartridge tube and tighten.
Wrap a rag around the bleed hole and firmly grasp the cartridge tube to
prevent fluid from ejecting from the bleed hole.
Slowly push the rebound shaft into the cartridge tube until there is about
30 mm of shaft exposed, and then fully extend again. Cycle the rebound
shaft a few times, always leaving 30 mm of shaft exposed, to purge the
system of excess fluid and air bubbles.
NOTICE
Do not push the rebound shaft all the way into the cartridge tube as this will
purge too much fluid. Always leave about 30 mm of shaft exposed.
⚠
CAUTION- EYE HAZARD
Cycle the rebound shaft slowly. Failure to do so can result in fluid ejecting
from the cartridge tube. Wear safety glasses.
23
24
25
12 mm 12.4 N·m (110 in-lb) Adj wrench
26