SRAM DualDrive 24, Техническое руководство, Страница: 69 / 76

Technical Manual 2006
67
i-LIGHT
ASSEMBLY / MAINTENANCE
N O !
C O N N E C T I N G C A B L E S
• Recommended wire specifications:
Inner wire size (AWG) 22 / Diameter
approx. 0.8 mm.
Insulation 1.8 – 2mm.
• Twist the cable wires before connecting
(Fig. 5) .
• Connect the cables . B end the cable wires
run them along the grooves (Fig. 6) .
Pay attention to a correct polarity. The
system doesn’t work in case of wrong
connection .
Kontrolle:
Rotate the front wheel and check the lamp
illumination.
Advice:
Hubs equipped with i-BRAKE:
Please read the i-BRAKE documentation.
M A I N T E N A N C E
• Do not disassemble the internal hub me-
chanism.
• Do not apply any lubricant to the inside of
the hub, otherwise the grease will come
out and it may cause problems with
conductivity.
• Compatible bulbs:
Front lamp 6 V, 2.4 W
Tail lamp 6 V, 0.6 W
Caution:
If the hub nuts are screwed on too tight, or
if one or the other is screwed tighter or
looser than the other, the hub axle may be
forced to turn. Making the hub nuts looser
or too tight, this could permanently damage
the hub axle.
3
4
6
5