SRAM DualDrive 24, Техническое руководство, Страница: 49 / 76

47
SPARC
ASSEMBLY
Technical Manual 2006
A S S E M B L Y B A T T E R Y B O X
• Pull both quick releases outward and
turn them to the „open“ position (Fig. 9) .
• Position battery box onto luggage
carrier struts (3, Fig. 7) .
• Push quick releases inwards and turn
them to the „closed“ position (Fig. 9) .
• Slide plug of battery cable in the slot of
the battery box until it snaps in.
• Attach cable along the frame or luggage
carrier strut.
Advice:
Last attachment point of the cable at the
rear fork: approx. 8 cm away from the
axle end.
Do not jam the cable between frame
and rear hub and keep it away from the
rotating hub shell.
• Slide plug in the slot on the hub until it
snaps in.
Advice:
Closed elements such as brazed-on eye
bolts are not suitable because plug will
not pass through.
S T O R I N G B A T T E R Y B O X
The battery box should be stored fully
charged in a dry and cool place. Remove
the plug of the battery cable from the box.
All batteries are shipped with an additional
documentation about the last charging
date within our SRAM facility. This
documentation of battery charging also
allows you to fill in the dates of additional
charge actions that you would need to
perform if the batteries stay in your
warehouse over a longer period of time.
You can identify the next necessary charge
date at a glance (at least 3 months after
last charge).
A S S E M B L Y R E M O T E
C O N T R O L U N I T
• Slide remote control unit (1, Fig. 10) onto
handlebar.
• Mount brake lever (2) and fixed grip (3).
• Adjust remote control unit on handlebar
and tighten the bolt (4) with a torque of
1.5 Nm (13 in.lbs.).
• Slide plug of remote control cable in the
slot (5) of the remote control unit until it
snaps in.
• Attach cable along the frame.
Advice:
Last attachment point of the cable at the
rear fork: approx. 8 cm away from the
axle end.
Do not jam the cable between frame
and rear hub.
Make a cable loop between plug and
cable attachment point to avoid tensile
load.
• Slide the plug straightly in the slot on the
hub until it snaps in.
Angular installation may damage the
slot.
Check:
Switch remote control to „Speed“ position
and rotate the rear wheel (Battery has to be
fully charged).
At least 1 green and the red LED must
gleam. If not, assemble plugs again
completely / right.
7
8
9
10
1
2 3
7
2
1
3
5
4
6
4
5
1
2
1
3
open closed