©2021 Spyker Spreaders/A Brinly-Hardy Co.
Page 13
1019225-D
Assembly
13. a)
Adding the Control Lever
Start to slide a hex head bolt (45), through the
remaining center hole on the handle.
End of the bolt comes out through
the side of the handle with the On/Off
sticker and the Control Lever Stop (73)
that was added on Step 9.
Do
NOT
push the bolt 100% through (yet).
At a sideways angle, slide the bottom hole of the
Control Lever onto the Linkage Bar (51).
See Fig. 13a
b) Twist the Control Lever toward the hopper and
then up, aligning the center hole of the Lever
with the bolt (45) that was added in the last step.
Push the bolt (45) through the Control Lever.
See Fig. 13b
12. Using Fig. 12 as a guide, insert a Hex Head Bolt
(46) through the remaining hole at the top of the
Lower Handle (52).
The bolt (46) should pass through the oval hole of
the Linkage Guide (47) and a washer (43). Loosely
secure in with a Nylon Lock Nut (3).
Do
NOT
tighten (yet).
Fig. 12
46
52
51
47
43
3
11.
Adding the Linkage Guide Plate.
Orientation is very important on this step.
For this step, please follow the illustration notations
below:
Fig. 11a
Use the lower, circular hole of
the Linkage Guide (47) and
add it to the Linkage bar (51).
51
47
Fig. 11b
Slightly lower linkage (51).
Slide guide (47) down linkage
& under the lower handle (52).
47
51
Fig. 11c
Lift the linkage (51), aligning the
top hole of the guide (47) with the
hole of the lower handle (52).
52
47
51
52
